Water extraction and drying
Standing water is pumped and extracted first, then wet materials are dried to moisture readings before anything is closed up.
Tide and rain backing up a low street, a nor'easter that found the roof, a pipe that split in a cold snap, a washer hose that let go. Call (833) 490-5225 at any hour. A crew is dispatched as fast as one is available, and the first steps are explained before equipment is set up.
Fastest: call (833) 490-5225. Or send this and we call you back.
Local weather drives activity here: heat, humidity and rain change what shows up week to week.
New London Water Damage Restoration answers water damage calls for New London, New London County and the towns along the Thames, 24/7. A crew is dispatched as fast as one is available. Standing water comes out first, then the wet structure is dried until moisture readings reach their targets, and photos and readings are kept for you and your insurer.
Water calls in a port city on a tidal river tend to start from one of a handful of places: stormwater and a high tide meeting in the drains, a nor'easter driving rain under flashing, a supply or drain line that failed inside an older house, or an appliance that leaked into a floor. The first steps differ by source, but the order does not: stop the water, take it out, then dry the structure until the readings say it is dry.
While you wait, close the main valve if a pipe is the source, keep the power off in wet rooms, stay out of standing water and photograph the damage from the dry side of the room. Those details are the first things a technician asks about, and they shorten the first visit.
Pick a service for symptoms, process and typical cost, or call and describe what you hear and see.
Standing water is pumped and extracted first, then wet materials are dried to moisture readings before anything is closed up.
Floodwater, silt and the materials it soaked are removed, the structure is cleaned and dried, and what cannot be saved is sorted out.
Surge water is pumped out, silt and debris are cleared, and the structure is cleaned and dried to readings.
Water is pumped from the basement, the source is identified, and the floor, walls and framing are cleaned and dried.
Contaminated water is removed, materials that cannot be cleaned are taken out, and surfaces are cleaned, sanitized and dried.
Mold follows water that was not dried. Remediation removes the growth, fixes the moisture and follows state guidance.
A frozen pipe splits in the cold and floods when it thaws. Shut the water off first, then dry what it soaked.
A leaking supply line keeps feeding a wall or ceiling under pressure. Find it, shut it off and dry what it wet.
A failed water heater tank can release its whole contents. Shut it off, remove the water and dry the floor and wall.
Washers, dishwashers and refrigerators leak into floors and subfloors. Shut the supply, then dry the materials beneath.
A stained or sagging ceiling means water is sitting above it. The source is traced, the wet layers are opened and dried, and the ceiling is made ready to rebuild.
Rain that gets past a roof wets the attic, the walls and the rooms below. The water is traced and the wet materials are removed or dried.
Water under a house wets the floor framing, the insulation and the ducts. It is pumped out, the wet material is removed and the space is dried.
When a sump pump stops during heavy rain or a high tide, basement water rises quickly. It is pumped out, wet materials are removed and the space is dried.
After water is removed, the building still holds moisture. Air movers and dehumidifiers dry it, and readings show when the structure is back to normal.
Phones are answered 24/7, holidays included, so a call at 3 a.m. about water spreading through a basement reaches a person who can walk you through the first steps.
Standing water is pumped or vacuumed out first. Air movers and dehumidifiers only work on moisture still held in the materials, not on a flooded floor.
Equipment stays until moisture readings for the wood, plaster, drywall and subfloor reach their dry targets, not for a fixed number of days.
Water that came up through a drain or in from the street carries what the street held. It gets its own handling steps, and so does a sewage backup.
Photos, moisture readings and a list of what was removed are kept as the work goes, so you can hand the facts to your insurer without rebuilding them from memory.
No price is printed on this site because the number depends on the loss. It is confirmed on site, before work starts, and each addition is described before it is done.
If a pipe or appliance is the source, shut off the main and keep clear of wet outlets. Then call the number at the top of the page. The first questions are where the water is coming from, whether it is still coming and which rooms are wet.
Do not wade into water near an outlet, a panel or the furnace. Keep children and pets out, and wait for a technician if the power to the area cannot be confirmed off.
A technician walks the wet rooms, marks the water line and takes moisture readings. The walkthrough decides whether the water is clean, from outside or from a drain, and that decides what can be saved.
Standing water goes first. Materials that cannot be dried in place come out with your approval. Drying runs to measured targets, and readings and photos are handed over at each visit.
Shut off the main water valve if the source is a pipe, turn off power to the wet rooms if you can reach the panel without standing in water, move small valuables up, and photograph the damage. Then call, before any cleanup, so the technician can tell you what to keep and what to leave in place.
A split supply line, a failed water heater tank or a dishwasher hose can put a great deal of water on a floor in a short time. Closing the main is the one step that stops the volume. Find the valve now, while nothing is wrong, and learn which way it turns.
Water that comes from outside is different. After a storm or a high tide it arrives carrying silt and whatever the street or yard held, and it should be treated as contaminated. Do not mop it up or run a household vacuum through it. A technician decides what comes out, and the flood cleanup page explains the steps.
Bank Street and South Water Street sit low, about 4 feet above mean sea level, behind a hurricane barrier, flood control conduits and a pumping station built by the Army Corps of Engineers. A 2015 city-commissioned study traced the trouble to stormwater overload and high tide backing water through the pipes.
The utilities director told a regional newspaper in December 2025 that Bank Street still floods when a high moon tide meets heavy rain, though overall flooding has been greatly reduced. That is the pattern worth knowing downtown: the water does not always come over a wall. It can come back up through the drains.
The same logic applies to a basement or ground floor anywhere near the river. The Bank Street guide lays out what the drainage study found, and the basement flooding page covers what a technician does when the water arrives from below.
Often it does. Roughly half of the city's homes date from before 1940, and older construction can hold water in plaster, thick framing and layered flooring that a newer house would shed. A technician reads moisture inside the wall, not just on the surface, before deciding whether a room can be dried in place.
About 47 percent of New London's housing units were built in 1939 or earlier, according to census-based summaries of American Community Survey data, and a regional housing report puts more than half of units before 1950. Two cutoffs, one stock of older houses.
In houses of that age, a wall can be plaster over lath, a floor can sit over old boards, and a basement wall can be stone or early concrete. Each holds moisture differently. A surface that feels dry can still read wet inside, which is why readings, not touch, decide when drying ends. The drying and dehumidification page explains how that goes.
The 1938 hurricane, Hurricane Carol in 1954 and Hurricane Sandy in 2012 each damaged New London or its neighbors, and surge was the common thread. They are named events with sources, not a calendar: no one can say when the next one comes, so the useful step is knowing what to do first.
Surge from the 1938 hurricane reached 10.6 feet above mean lower low water at New London, according to a local television news account, and the storm destroyed a quarter-mile stretch of Bank Street. Carol's storm tide in 1954 was reported at 9.6 feet. In October 2012, a post-storm damage survey recorded sustained winds of about 45 mph in New London and the most widespread damage of the day there.
Wind, rain and tide do different things to a building, and a technician sorts them on the walkthrough. The storm surge damage page describes the work, and the nor'easter basement guide covers the smaller storms that come more often.
ZIP 06385
ZIP 06340, 06349
ZIP 06357
ZIP 06335
ZIP 06333
ZIP 06355
ZIP 06382
ZIP 06339
ZIP 06372
ZIP 06353
ZIP 06370
ZIP 06378
ZIP 06371
ZIP 06360
ZIP 06365
ZIP 06379
ZIP 06334
ZIP 06359
ZIP 06475
ZIP 06380
New London, Connecticut · 25 km service radiusCall (833) 490-5225
We also cover many smaller communities across New London County. Check your ZIP.
Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what water damage restoration should cost.
A New London quote follows the size of the loss, the category of the water, how hard the affected rooms are to reach, whether mold has started, how many days of drying the materials need and how much of your contents must be moved.
Homeowners and renters policies in Connecticut generally cover sudden damage such as a burst pipe and generally exclude flood, which may sit under a separate flood policy.
Bank Street sits about 4 feet above mean sea level beside the Thames River estuary.
Phones are answered 24/7, holidays included. A crew is dispatched as fast as one is available, and no arrival time is promised. Say on the call whether the water is still coming, because that affects what you are told to do while you wait.
Small, clean spills, yes. Anything more than that, wait. Soaked carpet, pad and plaster should be photographed first, and water from a drain or from outside should not be mopped or vacuumed by hand. Shutting off the source and moving dry items is the safe first step.
No. The right figure depends on the size of the loss, the kind of water, access, drying time and what has to come out. The price is confirmed on site before work starts. The pricing guide explains what moves a quote.
It depends on the policy and on the source. The Connecticut Insurance Department says homeowners and renters policies generally cover storm damage from wind and fire and generally exclude flood, so a flood loss may sit with a separate flood policy. Ask your insurer, and keep notes of every conversation.
Treat it as contaminated and stay out until a technician has looked. Porous materials it touched, such as carpet, pad and drywall, are usually removed rather than dried, and the area is cleaned as a separate step.
Yes. The service area includes Waterford, Groton, Mystic, Norwich, Old Lyme and the other towns on the areas page. Give the street address and ZIP when you call and coverage is confirmed for that address.